原位拉伸法研究GH3625合金退火孪晶界稳定性及断裂行为

孪晶界作为低能稳定界面易在低层错能金属中被调控而成为近年来研究的热点.固溶态GH3625合金组织中含有大量退火孪晶组织.本实验采用室温原位拉伸结合扫描电子显微镜(SEM)观察和能谱(EDS)分析的方法研究了固溶态GH3625合金中孪晶组织演变及断裂行为.结果 表明,GH3625合金在原位拉伸变形过程中,孪晶组织内部主要...     

Capacitive and textural characteristics of hydrous manganese oxide prepared by anodic deposition

The amorphous hydrous manganese oxide (denoted as a-MnO_x·nH₂O) was anodically deposited from the MnSO₄ solutions of various pH values. The capacitive characteristics and stability of this oxide without and with annealing in air for 2 h up to 400 °C were systematically investigated in aqueous electrolytes through means of cyclic voltammetry (CV) and the constant-current charge-discharge method. The redox properties of a-MnO_x·nH₂O were strongly affected by the electrolytes employed and this oxide exhibited ideally capacitive behavior in 0.1 M Na₂SO₄ and 0.3 M KCl. The stability of this amorphous hydrous oxide was enhanced by the annealing treatment while its capacitance was gradually decreased with increasing the annealing temperature. The amorphous structure and surface morphologies of a-MnO_x·nH₂O with annealing at different temperatures were, respectively, examined in terms of the X-ray diffraction (XRD) patterns and scanning electron microscopic (SEM) photographs. The oxidation states of these a-MnO_x·nH₂O deposits were studied by X-ray photoelectron spectroscopy (XPS).     

硅钢退火炉氮气冷却的碳套辊分析

阐述了传统硅钢退火炉无冷却碳套辊的缺点,并介绍和分析了通氮气冷却碳套辊的技术特点。     

Low pressure annealing of gold nanostructures

Ultra-thin Au films sputtered on glass substrates were investigated. The samples were annealed in air and in an evacuated chamber. The dependence of the annealing process on ambient pressure during thermal treatment was studied. The thermally-induced changes in surface morphology were followed by atomic force microscopy. The changes have a great impact on dielectric, optical and physical properties of the prepared structures. UV–Vis absorption spectra were used to investigate optical parameters and showed the semiconducting characteristic of intrinsic Au clusters. It was found that reduced ambient pressure stabilizes the continuous structure of the thin gold film during the annealing process.     

Effects of annealing on the polymer solar cells based on CdSe-PVK electron acceptor

CdSe-poly(N-vinylcarbazole) (CdSe-PVK) nanocomposite was synthesized and utilized as the electron acceptor in the active layer of polymer solar cells. The photovoltaic properties of the polymer solar cells based on poly(3-hexylthiophene) (P3HT):CdSe-PVK as the active layer were investigated in detail. The effects of annealing temperature (100-200 °C) and time (5-60 min) on the device performance were studied. At annealing temperature of 150 °C for 30 min, the device demonstrated an optimal efficiency of 0.235% under AM 1.5 (100 mW cm⁻²) solar simulated light irradiation. The improved efficiency under the optimal conditions was confirmed by the highest light harvest in UV-vis spectra due to the increased crystallinity of P3HT after thermal annealing. Photoluminescence of these devices also exhibited that the quench effect increases with the increasing of annealing temperature, indicating that the charge separation between electron-donating (P3HT) and electron-accepting (CdSe-PVK) molecules was increased after heat treatment. Atomic force microscopy (AFM) images showed that the phase segregation and 3D interpenetrating networks of P3HT:CdSe-PVK were responsible for the enhancement of the device efficiency.     

Synthesis,structural and optical properties of Er doped,Li doped and Er + Li co-doped ZnO nanocrystallites by solution-combustion method

Pure zinc oxide (ZnO) and 2 mol% of Er, 1 mol% of Li individually doped and Er + Li co-doped ZnO nanopowders were synthesized by auto-combustion method. Crystal structure and grain size were characterized by X-ray diffractometer and found that all synthesized samples have hexagonal wurtzite crystal structure. Scanning electron microscope (SEM) and Transmission electron microscope (TEM) studies were used to determine the morphology and size of the nanocrystallites. A UV–VIS measurement shows four absorbance peaks in the visible regions and the band gap is slowly blue shifted after annealing at 800 °C. The presence of Er, Li and the hexagonal wurtzite structure was confirmed by FT-IR studies. FT-Raman spectroscopy has been employed to study the crystalline quality and structural disorders.     

Optimization by record dynamics

Large dynamical changes in thermalizing glassy systems are triggered by trajectories crossing record sized barriers, a behavior revealing the presence of a hierarchical structure in configuration space. The observation is here turned into a novel local search optimization algorithm dubbed record dynamics optimization, or RDO. RDO uses the Metropolis rule to accept or reject candidate solutions depending on the value of a parameter akin to the temperature and minimizes the cost function of the problem at hand through cycles where its ‘temperature’ is raised and subsequently decreased in order to expediently generate record high (and low) values of the cost function. Below, RDO is introduced and then tested by searching for the ground state of the Edwards–Anderson spin-glass model, in two and three spatial dimensions. A popular and highly efficient optimization algorithm, parallel tempering (PT), is applied to the same problem as a benchmark. RDO and PT turn out to produce solutions of similar quality for similar numerical effort, but RDO is simpler to program and additionally yields geometrical information on the system’s configuration space which is of interest in many applications. In particular, the effectiveness of RDO strongly indicates the presence of the above mentioned hierarchically organized configuration space, with metastable regions indexed by the cost (or energy) of the transition states connecting them.     

Controlled suppression of the photoluminescence superlinear dependence on excitation density in quantum dots

We have shown that it is possible to tune, up to complete suppression, the photoluminescence superlinear dependence on the excitation density in quantum dot samples at high temperatures by annealing treatments. The effect has been attributed to the reduction of the defectivity of the material induced by annealing.     

Effects of post-annealing on the microstructure and mechanical properties of friction stir processed Al–Mg–TiO2 nanocomposites

Aluminum matrix nanocomposites were fabricated via friction stir processing of an Al–Mg alloy with pre-inserted TiO₂ nanoparticles at different volume fractions of 3%, 5% and 6%. The nanocomposites were annealed at 300–500 °C for 1–5 h in air to study the effect of annealing on the microstructural changes and mechanical properties. Microstructural studies by scanning and transmission electron microscopy showed that new phases were formed during friction stir processing due to chemical reactions at the interface of TiO₂ with the aluminum matrix alloy. Reactive annealing completed the solid-state reactions, which led to a significant improvement in the ductility of the nanocomposites (more than three times) without deteriorating their tensile strength and hardness. Evaluation of the grain structure revealed that the presence of TiO₂ nanoparticles refined the grains during friction stir processing while the in situ formed nanoparticles hindered the grain growth upon the post-annealing treatment. Abnormal grain growth was observed after a prolonged annealing at 500 °C. The highest strength and ductility were obtained for the nanocomposites annealed at 400 °C for 3 h.